该文件包含一个STM32 OLED三级菜单框架。

简介：
The program begins with the initialization of the delay function, followed by disabling the JTAG interface via JTAG_Set(JTAG_SWD_DISABLE). Subsequently, the JTAG interface is enabled using JTAG_Set(SWD_ENABLE). TheNVIC interrupt group is configured with a priority scheme of 2 bits for preemptive priority and 2 bits for responsiveness priority: NVIC_PriorityGroupConfig(NVIC_PriorityGroup_2). The UART communication channel is then initialized at a baud rate of 9600. The LED hardware interface is initialized, along with the OLED display and the NRF24L01 transceiver. Analog-to-digital conversion (ADC) is initialized, and the KEY/EXTI input is configured. Finally, Timer3s interrupt function is initiated, setting a counting frequency of 10kHz and configuring it to trigger an interrupt after counting to 5000, resulting in a 500ms interval. The Detection_Hardware_Drive() function determines the current state of the hardware.